Sunday, March 19, 2017

CnC finally makes a move.

Yep, the CnC is moving under its own power now.  Next up...a few test cuts/drawings.

My extra large and clean workspace...aka dining room table that rarely gets used.

Yep, the CnC actually drew that ChiliPeppr logo on the table with that sharpie.

Stepping back a little this is the whole solution.  You can see the two power supplies on the left as well as the TinyG circuit board.

And here is the other side with the laptop that controls the cuts.
Closeup of the TinyG and its power supply.  Those wires go off to the 4 stepper motors.

Here is the back side with the nice wire chains.

No comments:

Post a Comment